Feed Lease Corporation, Engineered Solutions to coil handling and feed for stamping, including servo feeds, air feeds, straighteners, cradles, upenders, coil cars and complete systems

Air Feeds
Wire and Bar Air Feeds
Specifications

Air Feeds

Air feeds are a simple coil feeding option best suited to low volume operations. Feed Lease air feeds offer a high-strength, cast alloy gripper carriage, pilot release, outboard-mounted electrical controls and adjustable, double-acting air cushions. To simplify job set-up, hand wheel adjustment is provided for rapid stroke length adjustment.

Options include pull-through straighteners and air saver cylinders. Feed Lease air feeds are also available in Dual Grip, Zig Zag and Double models.

Standard Equipment
Accurate to + .001”
Precision fabricated steel feed base
High strength cast alloy gripper carriage
Pilot pin release electrical circuit
Outboard-mounted electrical controls (no reaching over material)
Adjustable double-acting air cushion
Numatics Inc. control valves 1/2” size on FL-2 thru FL-2-1/2 3/4” size on FL-3-1/4 thru FL-5 1” size on FL-6 & Dual Grip feeds
Rapid stroke length adjustment by means of hand wheel
Two-roll rear entrance stock guide with entrance vertical guide Side shield barrier safety guards
Noise control mufflers
Guide bar keeper plates Industry-standard interchangeable precision parts
Pre-drilled mounting bracket holes
Stock support rollers on models FL-2 thru FL-6, having stock width of 18” or wider
Manually adjustable stock peeler

Standard Features on FL-4 through FL-6
Mechanical numeric stroke length indicator
Adjustable stroke air saver cylinder
Right angle stroke adjustment by means of hand wheel

Standard Features, Pull-Through Straighteners
Feed Lease Corporation pull-through stock straighteners are available for all models of feeds and are designed to attach directly to the feeding unit. In operation, the stock is pulled through the straightener to effectively remove coil curvature and increase die life.

All pull-through straighteners are available with five, seven or nine rolls.
Pinch rolls: Either manual or power operation
Hand-held remote control to aid operator in threading of material (power units only)
Optional crodon surfaced pinch roll (maximum grip on material)
Air-operated pinch rolls
Air-operated clutch on powered pinch rolls

Wire Air Feeds

FLWF-5 with two-plane wire straightener designed to feed and straighten round, half round or flat wire. Inset shows optional seven-roll, two-planed straightener with optional flip-open feature.

Bar Air Feeds

Feed Lease bar feeds can be used as push-pull feeds for removing skeleton from press or for removing strip material from die.

These Feeds can also be designed to handle round, rectangular, I-beam channel and other special shaped bars.

Specifications

Models FL 1-1/2, 2, 2-1/2 & 3-1/4

Models FL 4, 5 & 6